Amplitude Serial Plotter

/*

 This example reads audio data from an Invensense's ICS43432 I2S microphone

 breakout board, and prints out the amplitude to the Serial console. The

 Serial Plotter built into the Arduino IDE can be used to plot the audio

 amplitude data (Tools -> Serial Plotter)

 Circuit:

 * Arduino Zero, MKRZero or MKR1000 board

 * ICS43432:

   * GND connected GND

   * 3.3V connected 3.3V (Zero) or VCC (MKR1000, MKRZero)

   * WS connected to pin 0 (Zero) or pin 3 (MKR1000, MKRZero)

   * CLK connected to pin 1 (Zero) or pin 2 (MKR1000, MKRZero)

   * SD connected to pin 9 (Zero) or pin A6 (MKR1000, MKRZero)

 created 23 November 2016

 by Sandeep Mistry

 */

#include <ArduinoSound.h>

// create an amplitude analyzer to be used with the I2S input

AmplitudeAnalyzer amplitudeAnalyzer;

void setup() {

  // Open serial communications and wait for port to open:

  // A baud rate of 115200 is used instead of 9600 for a faster data rate

  // on non-native USB ports

  Serial.begin(115200);

  while (!Serial) {

    ; // wait for serial port to connect. Needed for native USB port only

  }

  // setup the I2S audio input for 44.1 kHz with 32-bits per sample

  if (!AudioInI2S.begin(44100, 32)) {

    Serial.println("Failed to initialize I2S input!");

    while (1); // do nothing

  }

  // configure the I2S input as the input for the amplitude analyzer

  if (!amplitudeAnalyzer.input(AudioInI2S)) {

    Serial.println("Failed to set amplitude analyzer input!");

    while (1); // do nothing

  }
}

void loop() {

  // check if a new analysis is available

  if (amplitudeAnalyzer.available()) {

    // read the new amplitude

    int amplitude = amplitudeAnalyzer.read();

    // print out the amplititude to the serial monitor

    Serial.println(amplitude);

  }
}